Tel: () Eastman Avenue. Fax: () Ventura, Ca thel3l.me INSTALLATION METHOD FOR HEAD STUD KITS.
I am going to be using ARP head studs with my head swap this week/weekend and I had a question regarding the installation of them.. The.
Rod Bolts (5); Cylinder Head (11); Engine Block (5); Intake System (0); Engine Component (1); Accessory (0); Driveline (8); Tools (0).
Hex broach on the top of the stud for ease of installation. ·Each kit includes a complete set of L19 head studs, nuts, washers and ARP Assembly Lubricant.
In 2 steps: 1. 22 lb-ft 2. 61 lb-ft. B18B1 Torque Sequence: 8 4 2 6 10 With ARP head studs, most people add a step to the end of the OEM.
ARP head studs are a true staple in engine building. They're holding up so far, at about miles in a stock B18B1 swap. During the install the OEM header bolts which have never been removed in over , miles were extremely.
48 lb-ft you're going to have to install the ARP's with the old gasket torquing, use something to get any oil out of the head stud holes before installing them. .. b18b1, holset, 14psi, @ , 60ft - BONE STOCK.
get a spare nut or two. jam them together on the head side of the stud threads. install until whatever arp recommends. finish installing head. torque to what, 80 ft .